Concrete calculator

Enter the shape and size of your pour. You get the volume to order with a waste allowance, the number of premix bags, and a site mix if you plan to batch it yourself.

Updated October 23, 2026 · by Dmytro Antoniuk

Concrete volume

Units
Shape and size
ft
ft
in
Waste and ordering
%

5 to 10 % covers spillage and uneven digs.

Concrete to order1.30 yd³0.991 m³

Net volume1.23 yd³ 0.944 m³
Waste added5 %
Premix bags59 × 80 lb
Assumptions behind this result
  • Nominal dimensions as entered, no over-dig or spillage beyond the waste factor.
  • Waste allowance 5 % added to the net volume (typical 5 to 10 %, footings 10 to 15 %).
  • Premix yield 0.0170 m³ per 80lb bag (Quikrete premix yield 0.60 ft³ per 80 lb bag).

Estimate only. Quantities and checks are based on the dimensions and assumptions shown. This is not structural design and not a substitute for a geotechnical report or a licensed engineer. Confirm soil capacity, loads, frost depth and local code before you build or order.

How the concrete calculator works

The calculator finds the volume of the shape, adds the waste allowance you set, and then turns the result into premix bags and, if you choose a strength class, a site mix.

  • Box: length × width × thickness, for slabs, walls, steps and straight footings.
  • Round column or tube: π × radius² × height, for sonotubes and round piers.
  • Bell: π × h × (r² + r × R + R²) ÷ 3, the tapered cone at the bottom of a belled pier.

Imperial results come out in cubic yards because that is how ready-mix is sold in the US. Metric results are in cubic meters. Switching units converts the numbers you have typed.

Worked example: a 10 by 10 ft patio slab

A slab 10 ft long, 10 ft wide and 4 in thick:

Step Value
Volume in cubic feet 10 × 10 × (4 ÷ 12) = 33.3 ft³
Volume in cubic yards 33.3 ÷ 27 = 1.23 yd³
Plus 5 % waste 1.30 yd³
80 lb bags at 0.60 ft³ each 59 bags

At almost 60 bags, this pour is on the edge where a short ready-mix load starts to make sense. Bags give you time to work in sections; a truck gives you one consistent pour.

Bags or a site mix

Premix bags already contain cement, sand and gravel, so the count depends only on the yield the maker prints on the bag. The calculator uses 0.30, 0.45 and 0.60 cubic feet for 40, 60 and 80 lb bags.

If you mix from separate materials, pick a strength class. You get cement, sand, gravel and water for that class as a nominal recipe. It is a starting point for small, non-structural pours. For a footing or slab that carries a house, order ready-mix at the strength your plans or local code call for. Our guide to the concrete mix ratio explains where the recipe comes from and when 1:2:3 is good enough.

Next steps for a foundation

A plain volume is enough for a pad or a post. For a whole foundation, use the calculator built for it:

Common questions

How do I calculate cubic yards of concrete?

Multiply length by width by thickness in feet to get cubic feet, then divide by 27. A 10 by 10 ft slab 4 in thick is 10 × 10 × 0.333 = 33.3 cubic feet, which is 1.23 cubic yards before waste.

How many 80 lb bags of concrete make a cubic yard?

An 80 lb bag of premix yields about 0.60 cubic feet, so a cubic yard (27 cubic feet) takes 45 bags. With 60 lb bags (0.45 cubic feet) it is 60 bags, and with 40 lb bags (0.30 cubic feet) it is 90.

How much extra concrete should I order?

Order 5 to 10 % more than the net volume. Digs are rarely perfectly flat and forms bow a little. For footings dug straight into soil, many contractors add 10 % or more.

Is it cheaper to use bags or a ready-mix truck?

For a fence post or a small pad, bags are simpler. Past roughly one cubic yard, a ready-mix truck is usually cheaper and gives a more consistent concrete. Ask your supplier about their minimum load and short load fee.

Sources

  1. Quikrete, concrete project calculators and bag yields
  2. Inch Calculator, concrete footing calculator (waste and dig variance)
  3. ACI, cover for concrete cast against earth (FAQ)